hi, i have read through previous threads on the same issue and followed the instructions on a couple of sites. i have set the passwrod on the source server to a complex password. i have checked the date, time and zone on both source and destination server. i have even synced the itme to the source server. I can map a drive from the destination to the source, however, when i get to the section int he migration wizard where it tries to join the domain i get "very that the domain name and log on credentials are correct". Below is the last part of the SBS log. Any other ideas? Oh, i have checked the data and time the bios also. both servers are in an Esxi environment (same host).
i was hoping to post a snapshot of my log but can't do that. basically the log says
pinging old server name
ping reply status = success
connecting to domain and validating credentials
networking might not ready, retry 1 here
networking might not ready, retry 2 here
networking might not ready, retry 3 here
pinging old server name
ping reply status = success
