Hi All -
This same problem was posted a year back (by someone else), but no solution seems to be posted...
I downloaded the SBS2011 Std. evaluation from MSFT, and tried installing it. All works well, however in the final stages, I get an error, which seems to cut off the installation.
"FATAL: Add_CA_Role:"
After this, it just seems to stop the configuration, and goes to the Desktop. Not sure if the installation is done and the server is fine but it seems that I need to figure out what is wrong, fix it, and then try to do a clean install again.
Hardware specs are: PowerEdge 1950III - 2x Quad Core Xeon 2.66GB, 16GB RAM, 2x 163GB SAS
Would greatly appreciate some insight. Thanks!